top of page

THE WARHEAD INDUSTRIES BASE BRUSHLESS MOTOR LIKE ITS MORE EXPENSIVE COUNTERPART THE BLACK VERSION WAS DESIGNED FROM THE GROUND UP WITH OFFERING A MORE COST SENSISTIVE PRICE POINT IN MIND. A COMPLETE SET OF NEW MOULDS INCLUDING THE STATOR WERE USED TO PRODUCE THIS AWESOME BUDGET FRIENDLY BRUSHLESS AEG MOTOR.

WeChat Image_20210816110122.jpg

WARHEAD BASE AEG MOTOR

​

The Warhead BASE motor is designed to be a cheaper alternative to its older broth the CNC black version. It is available in FOUR different speeds in both long and short shaft variants. The motor is fully compatible with a host of ETU and mosfets including brands such as Jeftron, Gate and Perun. 

​

FOUR DIFFERENT SPEEDS AVAILABLE IN SHORT AND LONG SHAFT.


20K RPM AT 11.V

27K RPM AT 11.1V

35K AT 11.1V

45K AT 11.1V
 

CAST ALUMINIUM

CASING

HIGH QUALITY SPEED CONTROLLER WITH BUILT IN PROTECTION

GREAT TRIGGER RESPONSE AND EFFICIENCY

WHAT ARE THE DIFFERENCES BETWEEN THE BASE AND THE CNC BLACK VERSION.

airsoft-4498480_1920.png

The Warhead BASE motor was designed to offer a cheaper avenue into brushless motor technology in airsoft. As such there are several differences compared to the CNC black version. These are outlined by the table below.

brain.png
base1 motor.png
small motor final.png
comparrison.png

THREE DIFFERENT SPEED VARIANTS AVAILABLE

ULTRA FAST, HIGH SPEED AND LOW SPEED.

02.png

WHY USE A BRUSHLESS MOTOR IN YOUR AEG?

​

Brushless DC motors have no brushes to get worn out, they represent a huge leap forward in technology. Brushless output significantly higher efficiency and performance, and have a lower susceptibility to mechanical wear than their brushed counterparts.

Brushless motors offer several other advantages, including;

  • Higher torque to weight ratio

  • Increased torque per watt of power input (increased efficiency)

  • Increased reliability and lower maintenance requirements

  • Reduced operational and mechanical noise

  • Longer lifespan (no brush and commutator erosion)

  • Elimination of ionizing sparks from the commutator (ESD)

  • Near-elimination of electromagnetic interference (EMI)

assault-rifle-555882.png

JUST TAKE OUT YOUR ORIGINAL MOTOR AND USE THE EXISTING CONNECTORS ON YOUR AEG TO CONNECT YOUR NEW MOTOR.

MOTOR.png
base1 motor.png

CAST ALUMINIUM CASING

TOTAL CUSTOM IN-RUNNER DESIGN 

HIGH TEMPERATURE RESISTANT  QUALITY COPPER WINDINGS

HIGH QUALITY MAGNETS

BUILT IN ON-BOARD ESC WITH LOW VOLTAGE CUT-OFF AND OVER CURRENT DRAW TO PROTECT LIPO BATTERIES FROM OVER DISCHARGE

HIGHEST QUALITY REMOVABLE PINION GEAR FOR EASY SWITCH OUTS

DESIGN AND MANUFACTURE OF CUTTING EDGE AIRSOFT PRODUCTS AND SUPPORTING TECHNOLOGY

bottom of page